.. _Installing into Rack:

Installing into Rack
--------------------

To install the appliance into a rack, you need to attach outer rails to the rack, fix inner rails to the appliance, then slide the appliance into the rack. Read the section for detailed instructions.

#. Fully extend a rail assembly, which consists of inner, middle, and outer rails.

   FIGURE .. screenshot

#. Slide the front release latch to unlock the inner rail and remove the inner rail.

   FIGURE .. screenshot

#. Release the detent and slide the middle rail inward completely.

   FIGURE .. screenshot

#. (Optional) Remove the metal spacer for aluminum racks (UNCLEAR: REMOVE IF RACK IS ALUM. OR REMOVE IF RACK IS METAL (BECAUSE THE SPACER IS FOR ALUM. RACKS)).

   FIGURE .. screenshot

#. Fasten the front bracket to the rack with two M6x10mm screws at a desired position.

   FIGURE .. screenshot

   .. important:: Installing the appliance(s) starting from the bottom of the rack to keep it stable.

#. Fasten the back bracket to the rack with two M6x10mm screws (ARE THESE PROVIDED?) at the corresponding position on rack's opposite side.

#. Position the middle/outer rail assembly inside the rack and align its front end with the front bracket.

   FIGURE .. screenshot

#. Press the rail assembly's front end against the front bracket. Then push it to rack's side to hitch the assembly on the front bracket.

   FIGURE .. screenshot

#. Fasten the front end of the rail assembly with an M6x10mm screw to the front bracket.

#. Secure the rail assembly's back end to the back bracket like described in the three previous steps.

   FIGURE(S) .. screenshot

#. Repeat the steps above to install the second middle/outer rail assembly into the rack.

#. Fasten the inner rails to side of the appliance with provided screws.

   FIGURE(S) .. screenshot

#. Slide the appliance into the rack so that inner rails fit and lock in the middle rails.

   FIGURE(S) .. screenshot

